C8051F040的晶振程序3.pdfVIP

// // F04x_Oscillator_Crystal.c // // Copyright 2006 Silicon Laboratories, Inc. // // // Program Description: // // This example demonstrates how to initialize for and switch to an external // Crystal Oscillator. // - Pinout: // P0.0 - /SYSCLK // // P1.6 - LED // // all other port pins unused // // XTAL1 and XTAL2 - External Crystal Oscillator pins // // // How To Test: // // 1) Define the input external crystal frequency using Crystal_Clock // 2) Compile and download code to a F04x device. // 3) Run the code: // - the test will blink an LED at a frequency based on the External // Crystal frequency // - the F04x will also output the SYSCLK to a port pin (P0.0) for // observation // // // FID: 04X000011 // Target: C8051F04x // Tool chain: Keil C51 7.50 / Keil EVAL C51 // Command Line: None // // Release 1.0 // -Initial Revision (TP) // -1 JUNE 2006 // // // Includes // #include C8051F040.h // SFR declarations // // Global CONSTANTS // #define Crystal_Clock // External Crystal oscillator // frequency (Hz) // NOTE: This value will determine the // XFCN bits in ExtCrystalOsc_Init () // Timer2 using SYSCLK/12 as its time base // Timer2 counts 65536 SYSCLKs per Timer2 interrupt // LED target flash rate = 10 Hz // // If Crystal_Clock is too slow to divide into a number of counts, // count will always remain 0. #define LED_interrupt_count Crystal_Clock/12/65536/10 sfr16 RCAP2 = 0xCA; // Timer2 reload value sfr16 TMR2 = 0xCC; // Timer2 counter sbit LED = P1^6; // LED=1 means ON // // Function PROTOTYPES // void SYSCLK_Init (void); void ExtCrystalOsc_Init (void); void Port_Init (void); void Timer2_Init (void); void Timer2_ISR