电气装置安装计和施工-毕业论文外文翻译.docxVIP

The electric device is designed and constructed safely(1) illumination is designed and constructed with the lighting deviceFirst, general regulation1, When install the electric lighting device in the brick stone structure , should is it bury cliver , bolt , screw , expand bolt , nylon fill or the plastics are filled in regularly in advance to adopt; Forbid using the chuck. When designing has no regulationing, the above-mentioned regular bearing capacity of one should be matched with the weight of the electric lighting device.2, The dangerous bigger and more special dangerous place , act as the lamps and lanterns are highly smaller than 2 from the ground . At the 4M , should use specified voltage for 36V and following lighting lamps and lanterns , take protective measure.3, The wiring of the electric lighting device answers firmly , it should be good to keep in touch electrically; Need earth or metal part with electricity non- of connecting zero lamps and lanterns , switching , socketting etc., there should be special-purpose earth screw of the distinguishing mark.Second, lamps and lanterns1 , lamps and lanterns cant be installed on the flammable component directly; In the high-temperature position of lamps and lanterns surface when the flammable thing , should take insulating against heat , heat dissipation measure .2, In transformer substation, high pressure , low-voltage distribution equipment and bus bar, should not install the lamps and lanterns .3, The insulating outer cover of the lamp holder should have no damage and leak electricity. 4, To the lamp holder with switch, the switch handle should not have uncovered metal part.Third, socket1, installation of the socket should highly accord with the regulation designed , when designing has no regulationing, should accord with the following demands :2, It is highly unsuitable to be smaller than 1 to the ground . 3m nursery , the kindergarten and primary school are unsuitable to be smaller than 1. 8m; The socket ins