BESIII亮度监测器地运行结果.pptVIP

BESIII 亮度监测器的运行结果 薛镇 Outline 亮度监测器原理和结构 亮度监测器相对亮度的测量的精度 亮度监测器的bunch by bunch测量 利用亮度监测器对束团尺寸的测量 亮度监测器的原理和结构 亮度监测器的原理和结构 切伦科夫介质采用 熔融石英 (fused silica) 非常高的抗辐照性能 (109 rad/y) n=1.46 采用钨作转换体。 仅测计数，所占空间小。 主要用于相对测量 亮度监测器的原理和结构 相对亮度测量的精度 相对亮度测量的精度 相对亮度测量的精度 By steering the electron beam while observing the counting rate changes of the luminosity monitor, the horizontal and vertical sizes of the bunch spots can be estimated as shown in the figure. There are 70 e+ bunches and 10 e- bunches stored in the storage rings. The total e+ current is 321.660 mA, the total e- current is 54.758 mA. The data of the figure is of the fifth e+ and e- bunch pair. Fitted by gaussian function, the horizontal standard deviation σx=0.50±0.01mm, the vertical standard deviation is σy=0.0146±0.0003mm. * 单轫致辐射过程 e+ e- ? e+ e- ? 通过探测 ? 来确定亮度 截面大，可以实现快速更新 ～161 mb when kt=50MeV 出射的? 沿着束流方向且张开角度很小，0.5 mrad以内的光子占66%以上@1.89GeV “零角度亮度探测器” surrounded by tungsten shield Light pipe ? 钨 fused silica PMT 钨转换体厚为1.2cm。 熔融石英的几何尺寸为 4.5 x 4.0 x 6.6 cm3 According to Fig. (a) and (b) the ratio between the counting rates with separated beams and colliding beams are lower than 3.5%. Fig. (a) Counting rate with colliding beams normalized by the current of e- and e+  bunches vs. the FEE threshold. Fig. (b) Counting rate with separated beams normalized by the current of e- and e+  bunches vs. the FEE threshold. According to the table above the error of relative luminosity with threshold of 400mV and the pair of bunches currents of 5×5mA2 is about 0.9%. the counting rates and their errors due to different thresholds in SBBS  (I+=5.11mA,I-=5.00mA） 0.0081 0.0326 0.0222 0.0166 0.0134 0.0121 0.0111 0.0102 0.0092 0.0081 25 49 72 98 121 134 147 161 179 204 811 1866 4064 7414 11335 13853 16628 19914 24413 31775 0 4 8 11 14 16 17 20 24 29 0 17.5 58 120 192 250 306 420 575 857 25 39 57 78 96 106 116 127 141 161 649 15