外文翻译低电压反激式DCDC转换器在电源中应用.docVIP

Low Voltage Flyback DC-DC Converter For Power Supply Applications Hangzhou Liu1, John Elmes2, Kejiu Zhang1, Thomas X. Wu1, Issa Batarseh1 Department of Electrical Engineering and Computer Science, University of Central Florida, Orlando, FL 32816, USA Advanced Power Electronics Corporation, Orlando, FL 32826, USA Abstract — In this paper, we design a low voltage DC-DC converter with a flyback transformer. The converter will be used as a biased power supply to drive IGBTs. The flyback transformer using planar EI-core is designed and simulated using ANSYS PExprt software. Besides, anLT3574 IC chip from Linear Technology has been chosen for converter control. Finally, the converter modeling and simulation are presented and PCB layout is designed. Keywords：Flyback, anLT3574IC, PCB INTRODUCTION The goal of this project is to develop and build a prototype of a high-efficiency, high-temperature isolated DC-DC converter to be used as a biased power supply for driving a complementary IGBT pair. It is important that the converter can deliver the required power at an ambient temperature of up to 100℃; therefore it has to be efficient so that its components do not exceed their maximum temperature ratings. The final converter will be completely sealed and potted in a metal case. The input voltage range for this converter is from 9V to 36V. The output sides have two terminals, one is﹢16V and the other one is﹣6V. In order to get the desired performance, anLT3574 IC chip from Linear Technology is used. The key to this design is the flyback transformer. The transformer using planar EI-core is designed and simulated using ANSYS PExprt software. Finally, the PCB layout of the converter will be presented. KEY DESIGN OUTLINE For this flyback topology, the output voltage can be determined by both the transformer turns ratio and the flyback loop resistor pairs. Therefore, at the initial design stage, we can choose a convenient turn’s ratio for the transformer, and modify it later on if