router1配置文档.docVIP

Router1配置文档 Press Enter to Start Router Routerenable //进入特权模式 Router#config t（terminal） //进入全局配置模式 Enter configuration commands, one per line. End with CNTL/Z. Router(config)#hostname Router1 //设定主机名称为Router1 Router1(config)#enable secret 501 //设置特权加密口令为501 Router1(config)#^Z //结束全局配置 %SYS-5-CONFIG_I: Configured from console by console Router1#config t（terminal）//进入全局配置模式 Enter configuration commands, one per line. End with CNTL/Z. Router1(config)#int FastEthernet0/0 //进入配置模式，配置0/0端口 Router1(config-if)#ip address 192.5.5.1 255.255.255.0 //设置IP地址以及子网掩码 Router1(config-if)#no shutdown //激活当前接口 %LINK-3-UPDOWN: Interface FastEthernet0/0, changed state to up Router1(config-if)#^Z //结束全局配置 %SYS-5-CONFIG_I: Configured from console by console Router1#show int FastEthernet0/0 //查看指定0/0的以太口信息 FastEthernet0/0 is up, line protocol is up Hardware is Lance, address is 000C.1811.8229 (bia 000C.1811.8229) Internet address is 192.5.5.1/24 MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec, rely 255/255, load 1/255 Encapsulation ARPA, loopback not set, keepalive set (10 sec) ARP type: ARPA, ARP Timeout 04:00:00 Last input 00:00:00, output 00:00:00, output hang never Last clearing of show interface counters never Queueing strategy: fifo Output queue 0/40, 0 drops; input queue 0/75, 0 drops 5 minute input rate 1000 bits/sec, 2 packets/sec 5 minute output rate 1000 bits/sec, 2 packets/sec 0 packets input, 0 bytes, 0 no buffer Received 0 broadcasts, 0 runts, 0 giants, 0 throttles 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort 0 input packets with dribble condition detected 0 packets output, 0 bytes, 0 underruns 0 output errors, 0 collisions, 0 interface resets 0 babbles, 0 late collision, 0 deferred 0 lost carrier, 0 no carrier 0 output buffer failures, 0 output buffers swapped out Router1#config t（terminal） Enter configuration commands, one per line. End with CNTL/Z. Router1(config)#int Serial0/0/1 /