毕业设计—奇瑞a盘式制动器设计.doc

安徽工业大学 毕业设计(论文)任务书 毕业设计(论文)的主要内容： 一、说明书 1、盘式制动器概述 2、制动器总体结构确立和制动回路设计 3、制动器零件的设计和计算 4、设计结果及分析 5、结论 二、图纸内容 3张A0图纸,其中手绘A0图纸一张。 三、外文资料的译文5000字左右。 指导教师签字： 填写说明任务书封面请用鼠标点中各栏目横 线后将信息填入，字体设定为楷体－GB2312、四号字在填写内容时字体设定为楷体－GB2312、小四号字。 本说明书主要介绍了奇瑞A3轿车制动系统的设计。首先介绍了汽车制动系统的发展、结构、分类，并通过对鼓式制动器和盘式制动器的结构及优缺点进行分析。最终确定方案采用液压双回路，前后都为盘式制动器。除此之外，它还介绍了前后制动器、制动主缸的设计计算，主要部件的参数选择及制动管路布置形式等的设计过程。 关键词: 制动盘;制动轮缸;制动钳;制动衬片 Abstract The rapid development of the domestic vehicle market, saloon car is an important tendency of vehicle. However, with increasing of vehicle, security issues are arising from increasingly attracting attention, the braking system is one of important system of active safety. Therefore, how to design a high-performance braking system, to provide protection for safe driving is the main problem we must solve. In addition, with increasing competition of vehicle market, how to shorten the product development cycle, to improve design efficiency and to lower costs, to improve the market competitiveness of products, and has become a key to success of enterprises. The brake system in vehicle guarantied the safety of driving. Many rules and regulations have been made for the brake system in detail, which is the starting of our design. This paper mainly introduces the design of braking system of the CHERY A3 type of car. Fist of all, braking system’s development, structure and category are shown, and according to the structures, virtues and weakness of drum brake and disc brake, analysis is done. At last, the plan adopting hydroid two-backway brake with front disc and rear disc. Besides, this paper also introduces the designing process of front brake and rear brake, braking cylinder, parameter’s choice of main components braking and channel settings. Key words: braking; brake drum; brake disc; hydroid pressure  目 录 摘 要 I Abstract II 目 录 III 第一章 总 论 1 1.1汽车制动系概述 1 1.2制动系统设计的意义 3 1.3制动系统研究状态 4 1.4本次设计制动系统应达到的目标 4 1.5本次制动系统设计要求 4 第二章 制动系统设计方案论证分析和选择