XDM电机中英文对照说明书 - 副本.docVIP

XDM2系列三相异步电动机随机文件 Documents Provided With 3-Phase Induction Motor 山东华能传动物资贸易有限公司 XDM2系列电机使用维护说明书 ▲ 概述 ▲ 安装前的准备 ▲ 安装 OPERATION AND MAINTENANCE ▲ General This series motor is three-phase squirrel cage induction motor, which are suitable for driving all kinds of machines, such as metal cutting machine tools, pumps, ventilators, separators, hydraulic machines and other accessory equipments. ▲ Preparation before installation (1) Check all the data given on the nameplate, such as rated power, voltage, frequency and speed, if they are consistent with the actual demands. (2) Inspect carefully if the assemblies of all the parts are in condition and if the fixing parts are loose. Turn the rotor by hand to observe if there is any clogging. (3) Measure the insulation resistance between the phase windings and between windings to the ground with a 500V meager. During operation, the measured value should not be less than 1MΩ otherwise it must be dried. ▲ Installation of Motor (1) Any axial load will be not allowed in a vertical motor during operation. (2) The motor must be installed in a well-ventilating condition, and the clearance of the air in taking side of fan hood must not be less than the specified value on table 1. Table 1 Frame No. H63~132 H160~180 Above H200 Clearance (mm) 25 30 50 (3) The terminal box can be fixed in three directions except of the shaft extension side. If the direction of the terminal box needs changed, it can be moved by removing the four symmetrical bolts on the box. (4) After punching the rubber pad in the terminal box, the cable may be connected. And the packing nuts must be screwed up in accord with demands of waterproof and shockproof. (5) It is recommended to use coupling to link the motor, the second shaft must use coupling, if the motor has two shafts. To avoiding damage bearing, the coupling should be heated. (6) After installation, check all the fixing and joint parts see if they are re