Application Issues Solutions：应用问题及解决方案.pptVIP

Steel reinforced termination joint.Solution: Imbedded Fiberglass Mesh  Repair of termination joints. Completed repairs on termination joints DrainsExcessive material build-up. Solution:Geo-Seal (Create new substrate) Waterslide concrete support pillars.Solution: Geo-Seal Walking bridge pillars repair.Solution: Geo-Seal Conduit liner penetration.Solution: Liner re-installed under the conduit and re-sprayed Reservoir termination joints.Solutions: Trowel Grade Re-enforced protection on penetration detail. Solution: Geo-seal and re-sprayed. Repair of lap joints. Liner lock down pins.Solution: Re-install and Geo-seal. Installation of newVents and drainage Contaminated spray hose(with mineral spirits)Improper line flush Geo-seal joint tape Problem: Surface pin-holes. Improper application over coal tar pitch.No sealer previously applied. Surface blow holes, from off gassing of cold tar pitch Problem: Substrate not properly preparedSolution: Power wash any loose or poor concrete until they get a good firm substrate to adhere to.(may require a penetrating sealer if the concrete is too far gone.) Trapped water blisters. It is normal for some blistering to occur. A small number of blister heads should be sampled and checked for proper membrane thickness. If the samples have the required membrane thickness (80 mils nominal/60 mils minimum), then the remaining blisters should not be punctured or cut. If the samples have less than the minimum 60 mils, then the area can either be re-sprayed to obtain the proper thickness. Or the blisters can be cut out and the area re-sprayed or patched with Liquid Rubber Trowel Grade, to a minimum thickness of 80 dry mils over the cut-out area extending a minimum of three inches (3) beyond the cut. * * Application Issues  Solutions *