电阻支架的冲工艺及模具设计课程设计说明书.docxVIP

西南科技大学课程设计说明书 Ⅰ 电阻支架的冲压工艺及模具设计 摘要：在当今科技的迅猛发展的情形下，模具在生产制造过程中应用得越来越广，人们对模具的使用也越来越重视，从而它被大量运用到生产制造中来。模具技术的问世让工人的劳动强度降低，工作效率得到提高。因此它是一项具有重要的科技发明，具有重大的经济价值和利用发展空间。 本论文着重围绕了落料模具和弯曲卷圆复合模的设计来编写。文中粗略地介绍了冲模的发展状态和市场状况。重点对电阻支架进行了工艺分析并确定了工艺方案。根据冲模设计的主要步骤，着重对落料模和弯曲卷圆复合模这两套模具的主要零部件进行了相关计算与设计。如：凸凹模、凹模、凸模、凹模固定板、凸模模固定板、卷圆机构、垫板、卸料板等。结合标准件的选用标准，选用了模架、模柄、导柱导套、内六角螺钉等标准件及冲压设备。此外，落料模使用导料销和挡料销来定位工件，凸模固定板与落料凸模之间采用过盈配合，固定板与上模直接内六角螺栓连接，而落料凹模则采用直接与下模座连接；复合模具用了伸缩顶针来定位工件。在压力机的一个行程内先完成V形弯曲工序，随着压力机行程下降，滑块推动斜楔滑块完成卷圆工序。本套复合模具生产效率高，一模成形2个工件。以上模具结构设计足可以满足冲压产品的批量生产和精度要求及确保模具的正常稳定工作。 关键字：落料模具；弯曲卷圆复合模；凸凹模；伸缩顶针；卷圆机构 西南科技大学课程设计说明书 Ⅱ Bracket of the resistance of the stamping technology and die design based on 3d software Abstract：The rapid development of science and technology in todays circumstances, mold more and more applied in the manufacturing process, people are increasingly attention to the mold, so that it is applied to a large number of manufacturing.The advent of mold technology can reduce the labor intensity, and improve efficiency. So it is an important technological inventions, it has significant economic value and use of space for development. This thesis is focused around the blanking dies and bending rolling compound die `s design. This paper introduces dies state of development and market conditions. It was focusing on process analysis of Resistance stents and determining the process plan. According to the main steps of die design, it mainly introduce the components of molds for the relevant calculation and design.Such as: punch, die, punch and die mounting plate, punch mold fixing plate, rolling bodies, plate, stripper plate and so on.Combined with standard parts selection criteria, we used the standard mold, die handle, guide pins and bushings, hex screws and other standard parts and stamping equipment.In addition, blanking die used the guide pins and stop pin to fix the work