直流稳压源的设计_毕业设计.doc

直流稳压电源的设计 摘 要 本设计系统采用PWM发生器及驱动器为核心，设计附有储存、滤波、分时导通的可调直流稳压电源系统，具有结构简单、成本低、精度高等优点。很大程度上满足了稳压电源的应用需求，稳压电源以体积小、可调控范围广、效率高、应用范围广的目的而设计的。设计一个双管正激式它激型开关稳压电源电路，使其符合测量要求，主要过程是两个开关管分别轮流导通，传送能量使变压器变压，电流通过二极管和电感L给电容C充电同时对负载Rl供电。通过导通周期的互补，电容的充放电发生变化，这样就会使输出电源电压的范围发生变化。通过芯片SG3525进行反馈控制电路的占空比，输出采用滤波电路来实现设计要求。 关键词：滤波电路，稳压电源电路，SG3525，双管正激式开关电源。 AbstractThis design system using PWM generator and drive as the core, the design attached storage, filter, time-sharing conduction of adjustable dc regulated power supply system, has the advantages of simple structure, low cost and high accuracy. To a large extent satisfy the application demand of regulated power supply, regulated power supply with small size, wide regulating range, high efficiency, wide application scope and the purpose of design.Design a two pipe is shock type it shock type switch stabilized voltage supply circuit, make it conform to the requirements of the measurement, process are two main switch tube respectively conduction in turn, transmits energy transformer transformer, current through the diode and the inductance L to charging capacitance C to Rl load power supply at the same time. By conducting periodic complementary, charge and discharge capacity changes, this will make the output voltage range change. Through the chip SG3525 feedback control circuit of the duty cycle, output filter circuit is used to achieve the design requirements. key words: filter circuit, voltage stabilizing circuit,SG3525, the two pipe is shock type switching power supply. PAGE \* MERGEFORMAT IV PAGE \* MERGEFORMAT IV目 录TOC \o 1-3 \h \u HYPERLINK \l _Toc17290 第1章 绪 论 PAGEREF _Toc17290 1 HYPERLINK \l _Toc24365 1.1 选题目的及意义 PAGEREF _Toc24365 1 HYPERLINK \l _Toc29964 1.2 国内外研究概况 PAGEREF _Toc29964 2 HYPERLINK \l _Toc24457 1.3 本文主要设计内容 PAGEREF _Toc24457 3 HYPERLINK \l _Toc10353 第2章 方案论证与设计 PAGEREF _Toc10353 5 HYPERLINK \l _Toc20112 2.1 DC/DC主电路拓扑 PAGEREF _Toc20112 5 HYPERLINK \l _Toc19422 2.2 控制方法及实现方案 PAGEREF _Toc19422 5 HY