移相全桥零电压开关pw设计实现_毕业设计.docVIP

河北大学工商学院2013届本科毕业生论文（设计）PAGE 移相全桥零电压开关PWM设计实现摘 要移相全桥电路具有结构简单、易于恒频控制和高频化,通过变压器的漏感和功率开关器件的寄生电容构成谐振电路,使开关器件的应力减小、开关损耗减小等优点,被广泛应用于中大功率场合。近年来随着微处理器技术的发展，各种微控制器和数字信号处理器性能价格比的不断提高，采用数字控制已经成为大中功率开关电源的发展趋势。相对于用实现的模拟控制，数字控制有许多的优点。本文的设计采用TI公司的高速数字信号处理器TMS320F28027系列的DSP作为控制器。该模块通过采样移相全桥零电压DC-DC变换器的输出电压、输入电压及输出电流，通过实时计算得出移相PWM信号，然后经过驱动电路驱动移相全桥零电压DC-DC变换器的四个开关管来达到控制目的。实验表明这种控制策略是可行的，且控制模块可以很好的实现提出的控制策略。关键词：移相全桥；零电压；DSPPhase-shifted Full-bridge Zero-voltage Switching PWM Design and ImplementationABSTRACTPhase-shifted full-bridge circuit has the advantages of simple structure, easy to constant frequency control and high-frequency resonant circuit constituted by the leakage inductance of the transformer and the parasitic capacitance of the power switching devices, to reduce the stress of the switching devices, switching loss is reduced,which widely used in high-power occasion. In recent years, with the development of microprocessor technology, a variety of microcontrollers and digital signal processor cost performance continues to improve, the use of digital control has become the development trend of the large and medium-sized power switching power supply. Relative to achieve analog control, digital control has many advantages. The design uses DSP ,the TI company TMS320F28027 series of high-speed digital signal processor, as the controller. The module through the sampling phase-shifted full-bridge zero-voltage DC-DC converter output voltage, input voltage and output current, obtained through real-time calculation of phase-shifted PWM signal phase-shifted full-bridge zero-voltage DC-DC conversion, and then after the drive circuit the four switch control purposes. The experiments show that this control strategy is feasible, and the control module can achieve the proposed control strategy.Key words: phase-shifted full-bridge；zero-voltage；DSP 目 录 TOC \o 1-3 \u 　　1　引言 PAGEREF _Toc356984941 \h 1　　1.1　移相全桥软开关研究背景及现状 PAGEREF _Toc356984942 \h 1　　1.