cordys服务器管理维护手册.docVIP

Cordys服务器服务器配置Host : 在DMZ区IP为：2 和3 在综合网的IP为：2 和 3Hostname : cnpl-dataex03cnpl-dataex04Port ：21用户名：root 或者 cordyscordys服务1. 用secureCRT或xshell工具以root或cordys用户登录服务器， 执行下面的命令来查看cordys服务是否在运行service cars-slapd status #查看cordys ldap服务器是否在运行service wcpd status #查看cordys 服务器是否在运行service httpd status #查看apache服务器是否在运行2. 用secureCRT或xshell工具以root或cordys用户登录服务器， 执行下面的命令来停止cordys服务（注意执行的顺序），service httpd stop #停止apche服务service wcpd stop #停止cordys wcpd服务service cars-slapd stop #停止cordys ldap服务3. 用secureCRT或xshell工具以root或cordys用户登录服务器， 执行下面的命令来启动cordys服务（注意执行的顺序），service cars-slapd start #启动cordys ldap服务service wcpd start #启动cordys wcpd服务service httpd start #启动apache服务服务器状态查看磁盘空间状态：输入命令：$ df –m执行结果如下：查看当前进程CPU内存状态：输入命令：$ top执行结果如下：查看当前某个进程或者服务信息：(进程名是大小写区分的，可模糊匹配，可以只写部分)$ps –ef |grep –i 进程名例如：查看apache服务器的进程 $ps –ef|grep –i httpd ：常见问题以及解决方法1. How to Start and Stop Cordys Monitor?Problem Description How to start and stop the Cordys Monitor? Solution Run the following command: /etc/init.d/wcpd {start [-u user]| stop | restart [-u user]} The arguments for the above command are: stop – to stop Cordys Monitor, start – to start Cordys Monitor and restart – to stop and start Cordys Monitor. By default, Cordys Monitor will be running in the Cordys user?s context. To change the user context, use the –u option, which is available in the start and restart arguments. 2. Cordys Monitor fails to start if Multicast is disabledProblem Description Cordys Monitor fails to start if multicast is disabled and installer displays the following warning: Solution User can choose either of the following options: Yes –Installation will continue and monitor will not start after the installation. You can choose any of below provided solutions to start the Cordys Monitor service: ?? Select the standalone option during in the installationOr ??Go to Cordys CMC Cordys Properties and add the new property, workipaddress= No – Installer will exit and