年产2300吨可冷弯PVC电工套管生产车间设计本科（毕业设计）.docVIP

大连工业大学 2013届本科生毕业设计（论文） - PAGE II - 注：页眉，居中，楷体，五号。阅后删除此文本框。摘 要 注：页眉，居中，楷体，五号。阅后删除此文本框。 本设计为年产2300吨可冷弯PVC电工套管的配方、工艺流程以及车间的设计，管材的规格为Φ40×2.2mm。其中本设计绪论部分对PVC树脂、PVC管材的发展现状与前景以及PVC电工套管做了简单的介绍；配方设计部分主要对树脂的选择、助剂的选择及最终配方的确定做了详细的介绍；工艺流程设计部分主要是对生产方法进行选择，对工艺流程进行设计；物料衡算部分主要是确定各步工序的物料量和树脂及各助剂的用量；设备选型部分是利用物料衡算计算出的结果来对所需的设备进行选择，组要确定型号和台数；机头设计部分是根据管材的直径及厚度来确定机头的尺寸；车间布置设计部分主要是将设备合理的布置在车间内及车间内房间的设计；车间辅助设施的设计主要是合理的安排电气照明、供暖及通风；能量衡算部分主要对电、水、煤的用量进行计算；最后确定了本设计的投资金额以及对效益的分析。 关键词：PVC；管材；工艺流程；机头设计 Abstract The project is the formula of process design and workshop designed, pipe specifications for Φ40 × 2.2mm for an annual output of 2,300 tons of cold-formed PVC electrical conduit,. Introduction part of this design for PVC resin, PVC pipe development status and prospects, as well as PVC electrical casing brief introduction; The part of the formulating of recipe resin selection, the choice of the additives, and the final formula to determine the detailed introduction; The part of process design is mainly for the selecte of producing methords and process design; Material Balance is mainly to determine the amount of the process materials and resins and additives; The part pf equipment selection is use the material balance calculations calculated results to choose the required equipment group to determine the model number and the number of units; The design for the handpiece is based on the diameter and thickness of the pipe to determine the size of the handpiece; The part of the workshop is mainly about how to arrange the equipment in an reasonable way and the arrangement for the rooms in the workshop; The designe of workshop ancillary facilities is about how to arrange the electrical lighting, heating and ventilation; Energy balance just calculating for the major amount of electricity, water, coal; Finally, determine the amount of investment in the design and analysis of effective. Key Words：PVC；Tubes and pipes；Process flows；Handpiece design - Ⅲ - 目 录 TOC \o 1-3 \h \z \u HYPERLI