土木工程-外文翻译在不良地质条件下的隧道掘进.docVIP

PAGE 西南交通大学本科毕业设计 第 = 1 \* ROMAN I页 PAGE 西 南 交 通 大 学 本科毕业设计 外文翻译 年 级: 学 号: 姓 名: 专 业: 指导老师: 2012 年 6月 西南交通大学本科毕业设计 第 PAGE \* MERGEFORMAT 1页 TBM TUNNELLING IN DIFFICULT GROUND CONDITION Giovanni Barla and Sebastiano Pelizza ABSTRACT This paper is to discuss TBM tunneling in difficult ground conditions, when problems are met which may reduce dramatically the average progress rates and practical consequences may be such as to pose serious questions on the use of mechanized TBM tunnelling versus drill blast and other so-called traditional excavation methods. Following a few remarks on rock TBM tunnelling in relation to the selection and dimensioning of the machine, the attention is posed on the limiting geological conditions which may be envisaged with respect to the use of TBM tunnelling and on the importance of geological and geotechnical investigations, in order to derive an appropriate understanding of the rock mass conditions along the line of the tunnel. The discussion is centered upon the relatively more important or difficult ground conditions including borability limits, instability of excavation walls, instability of excavation face, fault zones and squeezing. Whenever available to the authors and based on project experience, the point of view is illustrated by case examples, which give the opportunity to underline specific difficulties encountered and recommendations. INTRODUCTION TBM excavation represent a big investment in an unflexible but potentially very fast method of excavating and supporting a rock tunnel (Barton, 1996). When unfavorable conditions are encountered without warning, time schedule and practical consequences are often far greater in a TBM driven tunnel than in a drill and blast tunnel. The unfavorable conditions can be produced by either a rock mass of very poor quality causing instabilit