克莱斯勒汽车材料标准-英文版.pdfVIP

Chrysler Group LLC Document Number: MS-10373S Material Standard Date Published: 2010-11-10 Category Code: B-4 Change Level: L EASL Requirement: Yes Restricted: No DUCTILE CAST IRON 1.0 GENERAL 1.1 Purpose of the Standard This standard describes the requirements for ductile (nodular) irons used in either the as-cast or heat treated condition. Grades A and AA are ferritic grades that are used in high ductility and impact resistant applications. Grades B, BH and BN are pearlitic grades and BQT is a martensitic grade used in high strength applications. This standard does not cover the requirements for austempered ductile iron (MS- 7959). 1.2 Purpose of the Material FERRITIC grades of ductile iron are used in high ductility and impact resistant applications such as suspension components. PEARLITIC grades of ductile iron are used in high strength applications such as crankshafts and brackets. MARTENSITIC grades are typically used for gears and can be produced to a wide range of properties; depending on the final hardness, this grade offers the highest wear resistance and the highest strength with corresponding reduced toughness and ductility. 1.3 Coverage of this Standard This standard covers the chemical composition, mechanical properties, physical properties; microstructure and heat treat requirements for these materials. 1.4 Correlation to Other Standards TABLE 1: MATERIAL STANDARD CROSS-REFERENCE MATRIX FERRITIC PEARLITIC MARTENSITIC Grade Grade A Grade AA Grade B Grade BH Grade BN Grade BQT