HONEYWELL-PKS-PID控制模块应用.pdfVIP

Topic: Cascade PID Control Module Contents Configure a Cascade PID Control Module 3 8/2/2004 ExperionPKS Control Execution Environment EXP04R201 1 Honeywell, Inc. This page was intentionally left blank. 2 ExperionPKS Control Execution Environment EXP04R201 8/2/2004 Honeywell, Inc. Cascade PID Control Module Configure a Cascade PID Control Module Configure a Cascade PID Control Module Practice Objective Configuring a cascade controller for T-100 bottom level control. Prerequisites • Experion PKS Server or a Client machine with Experion PKS Engineering Tools loaded. • Check if the Debutanizer_123 graphic is loaded on the Server. (This is required at a later time to check the control philosophy). • Control Builder is running with two tree windows open. • The SCE Controller and the IOMs are configured. • Excel Data Exchange open with the simulation spread sheet loaded. Introduction The first Cascade loop built is LC14, the T-100 bottom level control. Although the loop has two secondaries -- FC17 and FC18 -- in this lab the cascade is built with just 11_FC17. 11_ FC18 is configured in the next lab. The PID shows that this loop has an interlock with the bottom safety valve and is the Primary to both outlet streams (FC17 and FC18). LSD15 is driven by interlock logic, which trips the valve in the event of a low level. The trip is reset when the level is above 5%. The comparator for 5% will also be configured. The interlock (11_LSD15) will be imported into the proj ect. The cascade loop, with LC14 as primary and FC17 as secondary, will be built, and downloaded in this lab. However, the f