（毕业学术论文设计）-外文翻译--数控机床改造 (1).docVIP

PAGE 1 课 程 设 计 任 务 书 课程设计题目 钻孔用X-Y工作台及其运动控制系统的设计 指导教师 职称 专业名称 机电一体化工程 2080307 学生姓名 准考证号 020111252123 设计具体 内容与要求 序号 内容 1 总体设计方案的论证。 2 机械传动部件的设计与计算，并画出它的总装配图，以A1图纸绘制。 3 步进电机和棋驱动电路的选用与计算。 4 控制系统的设计，一A1图纸绘制电气控制原理图。 5 编写系统控制软件，对所附的零件图编写数控加工程序。 6 用A2图纸绘制系统框图。 课程设计提交资料 课程设计任务书，外文翻译，课程设计说明书，A1的装配图，A1的电气控制原理图，A2的系统框图。 交稿时间 2012年9月7日 南京理工大学机械工程学院 12年 8月 25日 南 京 理 工 大 学 课程设计说明书（英文翻译） - PAGE 2 - The Numerical Control Engine Bed Transforms Harvey B.M ackey First numerical control system development summary brief history and tendency In 1946 the first electronic accounting machine was born in the world, this indicated the humanity created has been possible to strengthen and partially to replace the mental labor the tool. It with the humanity these which in the agriculture, the industry society created only is strengthens the physical labor the tool to compare, got up the quantitive leap, entered the information society for the humanity to lay the foundation. After 6 years, in 1952, computer technology applied to the engine bed , the first numerical control engine bed were born in US. From this time on, the traditional engine bed has had the archery target change. Since nearly half century, the numerical control system has experienced two stages and six generation of development. 1.1 Numerical control (NC) stage (1952 ~ 1970) The early computer operating speed is low, was not big to then science computation and the data processing influence, but could not adapt the engine bed real-time control request. The people can not but use numeral logic circuit to build to become an engine bed special purpose computer to take the numerical control system, is called the hardware connection numerical control (HARD-WIRED NC), Jian Chengwei numerical control (NC). Along with the primary device development, this stage has had been through repe