[英文]RE500长期性能报告.pdf

Long-term behaviour of fastenings made with von: DMPg / Ginter Datum: 12.04.2001 Hilti Entwicklung Elektrowerkzeuge GmbH Hilti HIT-RE 500 Injection Mortar Seite: 1 / 16 Bereich Befestigungstechnik Hilti HIT-RE 500 Injection Mortar Long-term behaviour of fastenings made with HIT-RE 500 injection mortar Summary: Fastenings of reinforcing bars or threaded rods made with injection mortar Hilti HIT-RE 500 in concrete of quality C20/25 / 2000 psi are durable. Sustained load (creep) tests at loads above the design or recommended loads show low displacements for fastening element rebars as well as for HAS threaded rods. In all cases extrapolated displacements up to 50 years of service life stay within the displacement limits of control anchors or within approval requirements. This means fastenings with HIT-RE 500 are durable. The creep tests have been done in the temperature range up to 60°C / 140°F. In rebar fastening the limitation of crack width is an important aspect. Short- and long-term tests of HIT- RE 500 based on rebar-specific approval test procedures show fulfilment of the acceptance criteria. Only for permanent substrate temperatures 40°C/105°F and rebar sizes 16mm/#5 reduction of allowable bond strength might be necessary for crack width limitation (contact the Hilti technical service). A long-term test series to evaluate ultimate tensile loads for threaded rods as well as for rebars fastened with HIT-RE 500 is still running. After a test period of meanwhile 20 months there is no change either in ultimate loads or in load-displacement characteristic compared to anchors just after curing. Fastenings with HIT-RE 500 tested under freeze/tha