更换 DAE2P DAE3P LCC 模块.pdf

CLARiiON® Storage Systems Replacing a DAE2P/DAE3P LCC Module March 29, 2010 This document describes how to replace a link control card (LCC) in a CLARiiON® storage system DAE2P or DAE3P disk-array enclosure (DAE). Topics include: Handling field replaceable units (FRUs) 2 Removing an LCC 4 Installing an LCC 6 Verifying the operation of a new or replacement part using Navisphere Manager 8 Returning the failed part 9 1 Handling field replaceable units (FRUs) This section describes the precautions that you must take and the general procedures you must follow when removing, installing, and storing any field replaceable unit (FRU). Power issues and FRUs Your storage system is designed to be powered on continuously. Most components are hot swappable; that is, you can replace or install these components while the storage system is running. Front bezels should always be attached and each compartment should contain a FRU or filler panel to ensure EMI compliance and proper air flow over the FRUs. You should not remove a faulty FRU until you have a replacement available. When you replace or install FRUs, you can inadvertently damage the sensitive electronic circuits in the equipment by simply t