一个永磁直线同步电动机驱动的电梯门机的设计与研究--外文翻译.docVIP

毕业设计（论文）——外文翻译（原文） Design and Research of a PMLSM-Driven Elevator Door Machine Wang Xu-dong, Ren Ning-ning, Xu Xiao-zhuo School of Electrical Engineering and Automation Henan Polytechnic University Jiao Zuo, China E-mail:Renning66@163.com Abstract：Most of the existing elevator door driven by rotary motors, this paper used to design the permanent magnet linear synchronous motor as the Drive Fixed Motor,the door can eliminate the need of drive mechanism between the motor and the door, direct drive door in a straight line,improve reliability and security of the door machine. Through experimental analysis, the design uses DSP and Intelligent Power Module (IPM) combination of control system for elevator door operation by setting curve and stable operation. Keywords： Permanent magnet linear synchronous motor;Elevator Door Machine; DSP I. INTRODUCTION The traditional elevator door, warehouse door and civil came door-opening always drove by motor, because crane is a straight-line motion electromechanical integration device of frequent reciprocating,not only its operation and good safety requirements, but the smooth operation and low noise.Because the door is straight-line motion with reciprocating movement,the designation of a mechanical device,which transition the rotary motion of the motor to straight-line motion needed to realize the door open/close,is necessary.[1] At present elevator door market in domestic,drive motor mostly adopt AC asynchronous motor or linear motor, due to the high speed,position and difficult control of the AC asynchronous motor,it must have slow institutions contains belt or gear transmission etc,which make its structure complex,efficiency lowly,noisy and the performance of speed poorly. Though the performance of speed of linear motor is easy,but for the existence of commentator,the reliability is poor,and easy to produce electr