80T六梁桥式铸造起重机结构设计的毕业论文正稿.doc

WORD格式整理版 学习参考好帮手 80T六梁桥式铸造起重机结构设计的毕业论文 摘要 六梁铸造起重机是桥式起重机的重要组成部分，是中大型起重设备，由四根主梁和两根端梁组成。本设计采用偏轨箱型主梁，设计过程中从强度、刚度、稳定性三个方面来计算，对于A7工作级别的起重机来说还要进行疲劳强度校核，这就和A6以下工作级别的起重机的设计有了很大的区别，在设计时会出现静强度有很大的富余，在计算局部稳定性的时候还要注意局部轮压的作用，这时候需要验算加劲肋的区格验算，很有可能需要再次验算。设计中在满足刚度、强度、稳定性的前提下，探讨了该机型金属结构受力的空间传递分配规律，推导出内力计算公式。本文针对空间桥架内力的传递进行探讨，在一定假定条件下，得出主、副梁及主、端梁间的传递规律。 关键词：铸造起重机,应力, 疲劳强度, 稳定性 Abstract Casting six beams overhead cranes are an important component part of the medium and large lifting equipment, by the four main girder beams and two-component, the design based on the partial tracks box girder, the design process from the strength, stiffness, Stability three aspects, for the working-level A7 crane will run for calibration. This and the following working-level A6 crane design with vastly different, in the design when there are large static strength of the surplus in the calculation of regional stability but also to the partial pressure of the round, This needs time checking STIFFENER checking the grid, is likely to be checked again. The structure of the crane is composed of the primary centrol girder, the assistant centrol girder, the primary dead-end girder and the assistant dead-end girder according to the trait of the crane. On the advance of the intensity, rigidity and structure supporting the load is studied mainly. At the same time we also include the formulate which is used to calculate the internal force. Some kinds of conditions are assured in order to hold the internal relation between them. Key words: rigidity, intensity, fatigue strength, stability 第一章 总体方案设计 §1.1 原始参数 起重量Q(主/副) 180/50t 跨度S 22m 工作级别Ai A8 起升高度H(主/副) 20/22m 起升速度V(主/副) 4.5/11.4 m/min 运行速度(主/副/大车) 36/33.7/73.5 m/min 轮距(主/副/大车) 4080/1850/9800 mm 轨距(主/副/大车) 8700/3000/22000 mm 轮压(主/副/大车) 34500/19640/87600 kg 起重机重量