- 1、本文档共4页,可阅读全部内容。
- 2、原创力文档(book118)网站文档一经付费(服务费),不意味着购买了该文档的版权,仅供个人/单位学习、研究之用,不得用于商业用途,未经授权,严禁复制、发行、汇编、翻译或者网络传播等,侵权必究。
- 3、本站所有内容均由合作方或网友上传,本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺!文档内容仅供研究参考,付费前请自行鉴别。如您付费,意味着您自己接受本站规则且自行承担风险,本站不退款、不进行额外附加服务;查看《如何避免下载的几个坑》。如果您已付费下载过本站文档,您可以点击 这里二次下载。
- 4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等,请点击“版权申诉”(推荐),也可以打举报电话:400-050-0827(电话支持时间:9:00-18:30)。
查看更多
实用标准文案
精彩文档
下面是局域网的核心交换机(三层交换)和二层交换之间的端口聚合的操作实例:????2950????Switchen????Switch#conf t????Enter configuration commands, one per line.??End with CNTL/Z.????Switch(config)#int f0/1????Switch(config-if)#channel-group 1 mode on????%LINK-5-CHANGED: Interface Port-channel 1, changed state to up????%LINEPROTO-5-UPDOWN: Line protocol on Interface Port-channel 1, changed state to upSwitch(config-if)#int f0/2????Switch(config-if)#channel-group 1 mode on????3560????Switch(config)#int port-channel 1????Switch(config-if)#exit????Switch(config)#ip routing(默认已经启用了路由功能)????Switch(config)#int port-channel 1????Switch(config-if)#no switchport????Switch(config-if)#ip add 1.1.1.1 255.0.0.0????Switch(config-if)#no shut????Switch(config-if)#exit????Switch(config)#int f0/1????Switch(config-if)#no switchport????%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1, changed state to down????%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1, changed state to upSwitch(config-if)#????Switch(config-if)#no ip add????Switch(config-if)#channel-group 1 mode ???????active???? Enable LACP unconditionally??????auto?????? Enable PAgP only if a PAgP device is detected??????desirable??Enable PAgP unconditionally??????on???????? Enable Etherchannel only??????passive????Enable LACP only if a LACP device is detected????Switch(config-if)#channel-group 1 mode on????%LINK-5-CHANGED: Interface Port-channel 1, changed state to up????%LINEPROTO-5-UPDOWN: Line protocol on Interface Port-channel 1, changed state to up
Switch(config-if)#????Switch(config-if)#int f0/2????Switch(config-if)#no switchport????%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/2, changed state to down????%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/2, changed state to up
Switch(config-if)#no ip add????Switch(config-if)#no ip address????Switch(config-if)#channel-group 1 mode on????Switch(config-if)#exit????Swit
文档评论(0)