387弄59数控专业英语.pptVIP

* Early machine tools were designed so that the operator was standing in front of the machine while operating the controls. This design is no longer necessary, since in NC the operator no longer controls the machine tool movements. On conventional machine tools, only about 20 percent of the time was spent removing material. 早期的机床是操作者必须站在机床前操作，现在由于使用了NC，操作者就不必直接控制机床运动了。在传统机床上，只有大约20%的加工时间用来切削材料。 * With the addition of electronic controls, actual time spent removing metal has increased to 80 percent and even higher. It has also reduced the amount of time required to bring the cutting tool