基于MCGS和智能仪表的流量比值控制系统设计.doc

基于MCGS和智能仪表的流量比值控制系统设计 总计：毕业论文 27 页 表 格 2 表 插 图 11 指导教师 评 阅 人 完成日期 2013.5.26 大连大学学士学位论文 - PAGE IV - 摘 要 本文首先分析了实际工业生产过程中比值控制的意义和重要性,然后提出了流量比值控制系统的设计方案并在引入MCGS组态软件辅助控制的基础上加以研制,最后阐述了该系统调试的原理与步骤。利用AI808 智能仪表对锅炉的液位- 进水流量进行比值控制, 以北京昆仑公司组态软件MCGS实现上位机对现场进行实时组态、监控。 根据系统的工艺要求及实际需要，提出了流量比值控制的设计方案及硬件实施，着重说明了工控组态软件在设计开发计算机流量比值控制系统的应用。实际运行结果表明，系统不仅能够实现按不同比值关系进行控制，且使主、从动量均有较强的抗扰动能力，具有一定的实际应用价值。 关键词：比值控制；MCGS组态软件；AI-808智能调节器 Abstract This paper analyzes the significance and importance of the actual industrial processes ratio control, flow ratio control system design and then proposed to be developed on the basis of the introduction of the MCGS for auxiliary control, and finally elaborated the principle of the system debugging step. AI808 smart meter level of the boiler - water flow ratio control MCGS host computer in real-time on-site configuration, monitoring, the Beijing Kunlun configuration software. The design and the implementation proposal of current capacity ratio control were proposed according to the technological requirement of the systern and actual need in the paper and application of industrial control configuration software on designing and developing the flow ratio control system was highlighted. The results showed that the system can not only realize the different ratio control, but also enable the main and sub momentum to have strong noise-immune dynamic ability. It has certain practical application value. Keywords: Ratio control; MCGS configuration software; AI-808 intelligent regulator PAGE 目 录 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc358282053 摘 要 PAGEREF _Toc358282053 \h I HYPERLINK \l _Toc358282054 Abstract PAGEREF _Toc358282054 \h II HYPERLINK \l _Toc358282055 1 绪论 PAGEREF _Toc358282055 \h 3 HYPERLINK \l _Toc358282056 1.1 引言 PAGEREF _Toc35