1-s2.0-S13596 46209002012-main-外文参考资料.pdf

Available online at Scripta Materialia 61 (2009) 149–152 /locate/scriptamat Influence of carbon partitioning kinetics on final austenite fraction during quenching and partitioning A.J. Clarke,a,b,* J.G. Speer,b D.K. Matlock,b F.C. Rizzo,c D.V. Edmondsd and M.J. Santofimiae,f aMaterials Science and Technology Division, Los Alamos National Laboratory, Mail Stop G770, Los Alamos, NM 87545, USA bAdvanced Steel Processing and Products Research Center, Colorado School of Mines, Golden, CO 80401, USA c ´ ´ Department of Materials Science and Metallurgy, Pontifıcia Universidade Catolica-Rio de Janeiro, RJ 22543-900, Brazil dSchool of Process, Environmental and Materials Engineering, University of Leeds, Leeds LS2 9JT, UK eMaterials Innovation Institute (M2i), Mekelweg 2, 2628CD Delft, The Netherlands fDepartment of Materials Science and Engineering, Delft University of Technology, Mekelweg 2, 2628CD Delft, The Netherlands Received 12 March 2009; accepted 15 March 2009 Available online 19 March 2009 The quenching and partitioning (QP) process is a two-stage heat-treatment procedure proposed for producing steel microstruc- tures that contain carbon-enriched retained austenite. In QP processing, austenite stabilization is accomplished by carbon parti- tioning from supersaturated martensite. A quench temperature selection methodology was developed to predict an optimum process quench temperature; extension of this