工厂精确拉尺校正.ppt

FAC calibration for wheel balancer Editor: Song Zhi CHECKED：Li Chuanhong Version：A1001 Date：2010.10.21 The factory calibration program can be suitable for CB448 and CB460B. FAC calibration for truck wheel balancer Step 1: Power on the machine and install the 14” car tire on the wheel balancer then input the three parameter （dis/br/dia）of the tire. Step 2: Calibrate ----car tire DYN balance model Press the ENTER button , There shows “P” on the left display. Preparing work 100g lead 22.5” tire 14” tire FAC calibration for truck wheel balancer Press “Dis+” to enter “ SET –UP” Press “ENTER” to enter “IN–TES ” Then press “ENTER” to enter “POS” “XX” FAC calibration for truck wheel balancer Rotate the tire by hand slowly and the POS value will change. When there’s 110, Press key. Then continue to pull the tire and when there’s 120, press the key. FAC calibration for truck wheel balancer It will show the display “ADD”--” 0” like the following picture, then press the ” START” key. There will show “ADD”--”100” like the left picture after the tire stopped to rotate. FAC calibration for truck wheel balancer Pull the tire till the indicator light all shine, then put the 100g weight on the rim outside 12 o’clock place. Then press “START” key to run the machine for calibration. FAC calibration for truck wheel balancer There will show “100”--”ADD” on the display like below picture after the tire stopped to rotate.