思科路由器基本配置与常用配置命令.docVIP

思科路由器基本配置与常用配置命令(simple for CCNA)启动接口，分配IP地址：routerrouter enablerouter#router# configure terminalrouter(config)#router(config)# interface Type Portrouter(config-if)# no shutdownrouter(config-if)# ip address IP-Address Subnet-Maskrouter(config-if)# ＾z配置RIP路由协议：30秒更新一次router(config)# router riprouter(config-if)# network Network-Number?router(config-if)# ＾z配置IGRP路由协议：90秒更新一次router(config)# router igrp AS-Number?router(config-if)# network Network-Number?router(config-if)# ＾z配置Novell IPX路由协议：Novell RIP 60秒更新一次router(config)# ipx routing [node address]router(config)# ipx maximum-paths Paths?router(config)# interface Type Portrouter(config-if)# ipx network Network-Number [encapsulation encapsulation-type] [secondary]?router(config-if)# ＾z配置DDR：router(config)# dialer-list Group-Number protocol Protocol-Type permit [list ACL-Number]router(config)# interface bri 0router(config-if)# dialer-group Group-Numberrouter(config-if)# dialer map Protocol-Type Next-Hop-Address name Hostname Telphone-Numberrouter(config-if)# ＾z配置ISDN：router(config)# isdn swith-type Swith-Type?router(config-if)# ＾z配置Frame Relay：router(config-if)# encapsulation frame-relay [cisco | ietf ]router(config-if)# frame-relay lmi-type [ansi | cisco | q933a ]router(config-if)# bandwidth kilobitsrouter(config-if)# frame-relay invers-arp [ Protocol ] [dlci ]router(config-if)# ＾z配置标准ACL：router(config)# access-list Access-List-Number [ permit | deny ] source [ source-mask ]?router(config)# interface Type Portrouter(config-if)# ip access-group Access-List-Number [ in | out ]router(config-if)# ＾z配置扩展ACL：router(config)# access-list Access-List-Number [ permit | deny ] [ Protocol | Protocol-Number ] source source-wildcard [ Source-Port ] destination destination-wildcard [ Destination-Port ] [ established ]router(config)# interface Type Portrouter(config-if)# ip access-group Access-List-Number [ in | out ]router(config-if)# ＾z配置命名ACL：router(config)# ip access-list [ standard | e