入口段长度变化对于非预混火焰声场响应的影响及-中国电机工程学报.PDF

第 39 卷 第 1 期 中 国 电 机 工 程 学 报 Vol.39 No.1 Jan. 5, 2019 212 2019 年 1 月 5 日 Proceedings of the CSEE ©2019 Chin.Soc.for Elec.Eng. DOI ：10.13334/j.0258-8013.pcsee.180881 文章编号：0258-8013 (2019) 01-0212-07 中图分类号：TK 47 入口段长度变化对于非预混火焰声场响应的 影响及其被动控制 * 孟晟，周昊 ，陶成飞，刘子华 (能源清洁利用国家重点实验室(浙江大学) ，浙江省 杭州市 310027) Study of the Burner Inlet Length Variation Effect on Non-premixed Flame Response Under Forced Acoustic Excitation and Passive Control * MENG Sheng, ZHOU Hao , TAO Chengfei, LIU Zihua (State Key Laboratory of Clean Energy Utilization (Zhejiang University), Hangzhou 310027, Zhejiang Province, China) ABSTRACT: Non-premixed flame is widely used in the 利用多孔吸声板控制入口段长度 0.445m 时的火焰响应效果 industry, while its combustion instability is less focused. This 优良。 paper experimentally studied the inlet length variation effect on 关键词：非预混火焰；声场激励；燃烧不稳定；声场模拟； non-premixed flame response under acoustic excitation. The 被动控制；燃烧室；入口长度 inlet lengths of burner were set as 0.245, 0.345 and 0.445m. In the case of 0.245m and 0.345m inlet length, the maximum 0 引言 flame response frequency appeared at 144Hz, which related to fuel pipe acoustic mode by acoustic mode analysis. In the case 燃气轮机中，低污染燃烧技术如贫油预混燃烧 of 0.445m inlet length, the maximum flame response frequency 的采用，使得燃烧不稳定更容易发生[1] 。国内外燃 was 134Hz, which related a mixed mode of fuel pipe and 烧热声不稳定研究主要集中在贫预混燃烧[2-6]，而非 combustor. In this case, the maximum flame response reached