三维高密度集成电路中锥形硅通孔电特性.docx

-- - 升降横移式立体车库控制系统软件设计 摘要 本文总结了停车场的现状， 提出了立体车库城市的建设的必要性。 先进行 设计方案与论证，然后编程。使用两层三列五车位升降横移立体车库作为设 计的模型，我们完成升降横移立体车库控制系统的软件设计。引入检测和安 全装置。它的车库控制系统单片机控制， PLC控制，继电器控制。通过认真的 论证，本设计的控制系统最终选用了西门子 s7-200 型号的 PLC控制。用 PLC （可编程序控制器）设计地下升降横移式立体车库的控制系统。最后对其控 制系统的软件进行设计。画了程序流程图、 PLC接线图，分析了系统的控制流 程。并做了 PLC控制的梯形图和语句表，设计了车库控制系统软件设计。 升降横移立体车库的控制系统包含弱电和强电两套控制系统： 弱电系统主要包括终端位置检测、 自动方式停车、 急停各种信号检测、 到位检测、人员误入检测、超长检测、采集；报警与控制输出。 强电系统包括控制电机正反转接触器， 控制电机运行接触器， 控制接触器的接通与关断， PLC输出信号给接触器线圈。 关键词： 升降横移式立体车库，可编程控制器（ PLC），控制系统，强电系统，弱电系统。 Lifting and transferring type parking control system design Abstract:This paper summarizes the status of the parking lot, the necessity of building the citys parking garage. First design and demonstration programs, and programming. Use two-three five lifting and transferring parking garage as a three-dimensional model of the design, we complete lifting and transferring parking equipment control system software design. Introducing detection and safety devices. Its garage control system MCU control, PLC control, relay control. Through careful feasibility studies, the design of the control system for the final selection of the Mitsubishi FX-2N model PLC control. Lifting and transferring three-dimensional design of underground garage control systems PLC (programmable logic controller). Finally, the design of their control system software. Videos of the program flow, PLC wiring diagram, analysis of the control flow of the system. With GX Developer software to do the statement table ladder and PLC control, garage designed control system software design. Lifting and transferring parking equipment control system includes two sets of weak and strong electric control system: weak systems including terminal location detection, automatic parking mode, stop all kinds of signal detection, position detection, detection strayed personnel, long detection, collection; alarm and control output. The strong electric system includes a control motor reversing contactors, motor contactor, c