基于SG3525的两相BUCK变换器.docxVIP

8 - - - 摘要 目前，越来越多的设备已不仅仅可由单一电源供电，而要多个电源配合供电来保障大功率设备的正常工作。本文介绍以SG3525为核心，主体电路采用两路BUCK电路成相互配合的开关电源电路，介绍了SG3525芯片的工作原理及通过11脚，14脚两脚推挽输出，两脚相位差180度，通过控制2脚电压，来控制输出电压的占空比，从而影响负载的的电压。当11脚和14脚的输出电流达到5至10毫安就可以驱动光耦A3120，直接驱动mos管的栅极。从而驱动主电路。最后比较采样电压来决定改变占空比进行电压调整。当两路电源有一个支路出现故障时，另一路可以继续供电，保证了系统的正常工作，提高了供电的可靠性。 关键词：SG3525;PWM,开关电源 Abstract At?present,??the transition from unilateral power supply to multilateral power supplies is a big progress for power consumption equipment.It make sure of normal operation under high-power condition.This article describes a switching power supply circuit which is made of the SG3525 as the core and two BUCK circuits as the main circuit.In addition,it introduces how the SG3525 chip works and how to control the push-pull output through the 11 pin and the 14 pin.What the difference between two pins is 180 degrees,to control the bilateral voltage and the duty cycle of output power is a method of controlling the effect on load voltage.When the output current of the 11 pin and 14 pin reaches 5~10 mA,the A3120 OC will be drove, and after that the mos tube gate will be drove.So then it will drive the main circuit to work.Afterward,it will adjust the voltage by means of comparing the sampling voltage and correcting the duty cycle.If an error occurred in one branch of bilateral power supplies,the other would continue to work.That will ensure the system to work normally and improve the reliability of power supply. Key words: SG3525; PWM, switching power supply 目录 TOC \o 1-3 \h \z \u 中英文 HYPERLINK \l _Toc14463 摘要 PAGEREF _Toc14463 I HYPERLINK \l _Toc8951 1 引言 1 HYPERLINK \l _Toc17653 1.1 选题背景及实际意义 1 HYPERLINK \l _Toc5173 1.2 开关电源技术发展概况? PAGEREF _Toc5173 1 HYPERLINK \l _Toc14970 1.3本文的主要内容 1 HYPERLINK \l _Toc12430 2硬件介绍 3 HYPERLINK \l _Toc25818 2.1 SG3525引脚功能及特点简介 3 HYPERLINK \l _Toc20684 2.2 PWM控制基本原理 4 HYPERLINK \l _Toc19747 3系统设计 6 HYPERLINK \l _Toc18315 3.1 实现功能 6 HYPERLINK \l _Toc14905 3.2 总系统框图 6 HYPERLINK \l _Toc27631 3.3 DC/DC降压变换器方