ACS6000控制单元以及接线端子.pptVIP

Date ACS6000控制单元和接线端子 Name, department/event, date ACS6000接线端子介绍 ACS6000控制单元介绍 所有的控制硬件安装在控制单元摇门上 摇门开启后可以进入接线端子 一个通用的控制单元满足所有的基本控制要求 在多传中，每个电机对应一套控制单元 ACS6000单传动配置 ACS6000多传动配置 ACS6000AMC3板 AMC3 为电机控制主板，处理所有的电机和传动的信息与状态。 储存有程序代码，初始参数值 8 DDCS 通讯通道, 1-4 MBPS 2 PPCS通讯通道, 8 MBPS 状态指示 LED ACS6000AMC3存储器 ACS6000AMC3通道 ACS6000AMC3控制软件 ACS6000光电中断板 发生严重故障时迅速执行MCB跳闸 第一套INU INT板和S800 I/O之间直接通讯 “低电平有效” 的光电信号来自第一块INU INT板 ? ABB Group * | Slide * ? ABB Group * | Slide * Terminal Unit (TEU) ? Terminal unit (TEU) and control unit (COU) are installed into the same cabinet ? Mains and motor cables can be connected to the cabinet either from the top or through the bottom of the cabinet ? Cables will be connected to the internal bus bars in the cable connection field, located in the center area of the cabinet ? A separate connection section (power ground) is provided for cable shielding connections ? Dependig on the amount of rectifiers/inverters connected to the TEU, 600 mm or 1000 mm cabinets are used. Control Unit ? Responsible for most of the converter control, monitoring and protection tasks ? Control for rectifier (ARU) and inverter ? Current control for the excitation system ? Controlling and monitoring motor(s) (INU) ? Control and monitoring of trafo and MCB ? Control and monitoring of the water cooling system (control HW for ACS 6000 cooling is installed on swing frame inside of WCU cabinet) ? Local operation with CDP 312 panel and push buttons on the control cabinet door The following three I/O configurations are possible: Standard configuration The standard configuration includes the converter related functions (i.e. interface to the MCB), the AF100 fieldbus communication interface and the local control panel. Option CIW1 This option provides additional five I/O modules (S800 modules) with predefined I/Os for transformer and motor auxiliaries. Option CIW2 This option provides a programmable AC80 controller with the same I/O configuration as option CIW1. Additi