分配交换机的端口到VLAN中vlan-membership.PPTVIP

Slide 2 of 2 Purpose: Emphasize: Note: In the slide, the VLAN database was last modified locally. The IP address of wg_sw_a is 10.1.1.40. In the lab, the 1900s are running version 8.01.01, prunning was disabled by default. In the documentation, prunning is suppose to be enabled by default. Slide 1 of 2 Purpose: Emphasize: Each VLAN has a unique, four-digit number that can be from 1 to 1001. To add a VLAN to the VLAN database, the minimum parameter required is the VLAN number. Slide 2 of 2 Purpose: Emphasize: Slide 1 of 2 Purpose: Emphasize: Slide 2 of 2 Purpose: Emphasize: Note: Type: Default is ethernet. (other types are FDDI and Token Ring) SAID: Is used for FDDI trunking. MTU: Default is 1500 for ethernet vlan. STP: The 1900 only supports 802.1d STP. It does not support DEC or IBM STP. Routers support all three STP standards. Other parameters: Used for Token Ring or FDDI VLANs. Slide 1 of 1 Purpose: Emphasize: Note: The output shows that there are currently no ports assigned to VLAN 9. Slide 1 of 2 Purpose: Emphasize: By default, all ports are in VLAN 1. Slide 2 of 2 Purpose: Emphasize: Note: In the lab, we will only be configuring static VLAN membership. Slide 1 of 2 Purpose: Emphasize: Slide 2 of 2 Purpose: Emphasize: Port 1 = e0/1, ……. AUI = e0/25, A = fa 0/26, B = fa 0/27 Slide 1 of 1 Purpose: Emphasize: 分配交换机的端口到VLAN中 vlan-membership {static {vlan#} | dynamic} wg_sw_a(config-if)# 分配交换机的端口到VLAN中 wg_sw_a#conf terminal Enter configuration commands, one per line. End with CNTL/Z wg_sw_a(config)#interface ethernet 0/8 wg_sw_a(config-if)#vlan-membership static 9 vlan-membership {static {vlan#} | dynamic} wg_sw_a(config-if)# 查看VLAN中的成员 wg_sw_a#show vlan-membership 查看VLAN中的成员 wg_sw_a#show vlan-membership Port VLAN Membership Type Port VLAN Membership Type -------------------------------------------- ----------------------------------------- 1 5 Static 13 1