Agilis测量系统 - 检查清单和光学测试设置.pdf

NSMS Checklist Test Setup Optical Confidentiality Statement The information contained in this document and referenced material is confidential and proprietary business information of Agilis Measurement Systems, Inc.TM This information cannot be disclosed to any third party, and must be secured and maintained as confidential at all times. © 2012 Agilis Measurement Systems, Inc. TM Export Controlled This document contains information within the purview of the Export Administration Regulations (EAR), 15 CFR 730-774, and is export controlled. Transfer or export contrary to U.S. law is prohibited. ECCN: 9E990 / No License Required 2014 Agilis Measurement Systems, Inc. Proprietary and Confidential. Use or disclosure of the data contained in this page is subject to the restrictions on the first page of this document 1 Simplified Checklist 1. Clean Probes 11. Rotate rotor 2. Turn on computer (If system has PXI 12. Check probes in Scope Mode. (Flat Chassis, it must be on first) line? Any line?) 3. Check connections 13. Check condition of all probes 4. Check computer IP address to IP of 14. Check Identity of each probe (Cycle laser box compatibility on and off) 5. Check Laser communication through 15. Set zooms and triggers for all probes NI Measurement Automation: Test channels for “Success when “Writing 16. Set sample rate voltage 17. Enter Acquisition mode 6. Turn on cooling/purge ai