印染废水处理工艺 环境工程等专业毕业设计 毕业论文.docVIP

PAGE PAGE 40 第 PAGE 1页 摘 要 废水处理厂设计规模2000m3/d，设计水质水量为：Q=2000m3/d,BOD5=230mg/L，CODcr=1100mg/L， PH=9～11，SS=210 ㎎/l ,色度400倍。经处理后，应达到下列出水水质：BOD≤25mg/L,COD≤100mg/L，色度≤40倍，SS≤70mg/L,PH=6～9。 本设计采用水解酸化加生物接触氧化处理废水。处理构筑物主要有调节池、水解酸化池、生物接触氧化池、竖流式沉淀池、浓缩池、泵房、脱水机房和鼓风机房等。其主要构筑物生物接触氧化池采用传统的一段式接触氧化，总共采用两座，每座分为四格，处理效果明显。预处理的调节池和水解酸化池有效的降低了污水的各项指标，为生物接触氧化池的进水，提供了最佳进水指标，同时还有效的降低了污水的色度，再加上后面的竖流式沉淀池的絮凝沉淀作用，色度指标大大降低，基本上可以满足出水的要求。 关键词：印染废水 废水处理 生物接触氧化  Abstract The designing scale of waste water treatment plant is 2000 m3/d, the designing quality and quantity of water are: Q=2000m3/d ，BOD5=230mg/L, CODcr=1100mg/L ,PH=9～11 ,SS=210 ㎎/l ,Color degree=400times. After disposing of it, the quality of water should attain the following standards: BOD≤25mg/L,COD≤100mg/L，SS≤70mg/L，Chroma ≤ 40 times，PH=6～ The design acid hydrolysis Biological oxidation wastewater treatment. Dealing with the main structures regulation pool, pool acid hydrolysis, biological oxidation pond, the vertical flow sedimentation tank, concentrated pool, pumping stations, Dehydration room and the other blower. The main structures of biological oxidation pond used for the traditional contact-oxidation, using a total of two, each divided into four blocks. significant treatment effect. Pretreatment Regulation pools and pool acid hydrolysis effectively reduce the sewage indicators of biological oxidation pond inundated. Intake provides the best indicator, but also effectively reduce sewage color, plus behind the vertical flow sedimentation tank of flocculation and sedimentation, color indicators greatly reduced. Basically meet water requirements. KEY WORDS: textile printing and dyeing wastewater Keywords : dyeing wastewater wastewater treatment biological oxidation  目 录 TOC \o 1-3 \h \z \u 摘 要 I Abstract II 目 录 III 前 言 V 第一章 绪论 1 1.1 印染废水的产生及特点 1 1.2 印染废水的水质及水量分析 1 1.2.1 不同产品排放的废水水质 1 1.2.2 废水水量