基于UG的风扇工业产品设计制造及运动仿真毕业论文.docVIP

常州工学院机电工程学院毕业论文 PAGE 1 摘要：本文主要以风扇为研究对象，通过UG对风扇进行了设计，分别建立了风扇的叶片、基座、转头机构、电动机的三维模型，并对叶片进行了模拟加工。根据风扇转头的机械原理，对风扇进行了运动仿真，通过添加连杆、转动副、齿轮使得它们按照给定的转速比运转。 本文的设计方法通过虚拟设计、虚拟装配，运动仿真，可以验证设计、装配和操作过程与结果的正确与否，以便及早的发现机构设计的问题，对模型进行修改，减少成本损失，并通过可视化显示装配，然后以求达到准确仿真运动，使生产真正在高效、高质量、短时间、低成本的环境下完成，同时又具备了良好的服务。 关键词： UG 叶片 模拟加工 运动仿真 Abstract：Article mainly fan for research object, Through the design of fan UG, The paper established the fan blade, base, turned institutions, 3d model of electric motor，And the blade is simulated processing. According to the principles of mechanical, fan turned to fan carries on movement simulation, By adding connecting rod, rotating vice, gear makes them according to the given speed than operation. This design method through the virtual design, virtual assembling, motion simulation, can verify design, assembly and operation process and result is correct or not, facilitate early discovery mechanism design problem of model, modify, reduce cost losses, and through the visual display assembly, then to achieve accurate simulation campaign that produce real in high efficiency, high quality, short time, low cost environment, but have the complete good service. Keywords : UG lamina Simulation processing NC simulation process 目录 1.绪论…………………………………………………………………………………………4 1.1UG的概述 …………………………………………………………………………………4 1.1.1 UG的组成 ……………………………………………………………………………4 1.2设计目的 ………………………………………………………………………………6 1.3设计要求 …………………………………………………………………………………6 2.基于UG的风扇设计………………………………………………………………………7 2.1风扇的原理……………………………… ………………………………………………7 2.1.1风扇的基本组成 ………………………………………………………………………7 2.1.2工作原理 ………………………………………………………………………………7 2.2风扇零件的造型 …………………………………………………………………………8 2.2.1叶片 ……………………………………………………………………………………8 2.2.2机架……………………………………………………………………………………11 2.2.2.1第一台风扇的机架 ………………………………………………………………11 2.2.2.2第二台风扇的机架 ………………………………………