Kenwood TK-90调频板 英文手册（含：电子原理图+安装说明）.pdf

Technical Manual SC90 Selcall Board for use with Kenwood TK90 Radio Jenal Communications Pty Ltd Issue 2.00 - 15 Jun 2009 SC90 Operation Basic Commands keys: A – Channel Up Steps radio up one channel at a time - wraps to lowest channel Also used to step through menus. B – Channel Down Steps radio down one channel at a time - wraps to highest channel Also used to step through menus. C – Enter Call Menu (See page 2.1) D – Enter Data/Display Menu (See page 3.1) r – Scan/Mute on/off If the TK90 is in normal mode and scanning is enabled then pressing r starts scanning and sets mute ON. If the TK90 is scanning, or mute is on, then pressing r stops scanning and/or switches mute OFF. The TK90 will ump to the channel it was on when scanning was started. If the TK90 is scanning and a call has been received then pressing r stops scanning and switches mute OFF. The TK90 will jump to the channel it was on when the call was received. If the TK90 is in alarm mode then pressing r will cancel the alarm and reset the display. r is also used as a general delete, back space or exit command depending on where it is used. PTT - PTT can also be used to exit a function or cancel an alarm. Warning: If PTT is pressed while the TK90 is scanning then scanning will stop and the radio will transmit on the current scan channel. When the PTT is released the TK90 will jump back to the channel it was on when scanning was started or to the channel an incoming call was received on. Because of this the PTT should only be pressed momentarily to stop scanning. # – Mute only on Pressing # will switch the