15000 m3每小时喷漆废气治理工程设计毕业论文.docVIP

广东工业大学2006届本科生毕业设计（论文） 15000 m3 PAGE 15000 m 15000 m3/h 喷漆废气治理工程设计 叶丽杰 计 毕业设计（论文） 15000 治理工程设计 学 院 环境科学与工程 专 业 环境工程 年 级 2009级1班 学 号 3123008171 姓 名 周常月 指导教师 黄树杰（校外） 陈凡植 （2013 年 6月6 广东工业大学教务处制 广东工业大学2008届本科生毕业设计（论文） 15000 m3 PAGE I 摘 要 本设计将介绍一种有效的喷漆废气净化技术—吸附浓缩与催化燃烧.设计选用蜂窝状活性炭做为吸附剂，其具有吸附性能好，流体阻力小的特点。通过蜂窝状活性炭的吸附浓缩作用,将大风量、低浓度的有机废气转换成小风量、高浓度的有机废气,后者可在催化燃烧床上转变成无害的CO2 和H2O ,并保持稳定的自燃烧态。与传统工艺相比,采用该方法具有净化效率高、无二次污染、运行成本低的优点。 首先本文将概述当前喷漆废气处理的现状，主要处理方法和优缺点，并且阐述本设计所采用该技术的原因。 其次，本文将系统介绍所采用技术的基本原理，设计原则和设计过程计算。 最后，对本毕业设计进行工程预算，确定经济可行性。 在附录中，本文还将给出一些必要的设计资料，供参考之用。 关键词：喷漆废气，吸附浓缩，催化燃烧，蜂窝状活性炭 Abstract The design introduced an effective technology of adsorption concentration and catalyticcombustion for cleaning spray-paint waste gas. The design choose honeycomb-shaped activated carbon as sorbent,which has large adsorption ability and low resistance. By its concentrating adsorption , large flow and low concentration of organicwaste gas were changed to smaller flow and higher concentration. The latter was passed into catalytic combustion chamber to convertinto carbon dioxide and water , which could maintain self-burning. Compared to traditional technology , this technology has the advantages of high purification efficiency , no residual waste generation , and low maintenance costs. At first , I will introduce the characteristics, application,and the present situation of cleaning of spray-paint saste gas,and then principles of them,explaining the reason to choose the technology. The second,I will describe the principle,design method. The last,I will do the budget of the projet，to make sure the availability of the design. At the supplement,I will write sone thing like program code,dialogs and so on.It may be helpful for the future design. Keywords : spray-paint cwaste gas, adsorption concentration , catalytic combustion, honeycomb-