AASHTO 间接拉伸试验的试件准备.pdfVIP

Proposed Standard Practice for Preparation of Indirect Tension Performance Test Specimens AASHTO Designation: PP XX-XX 1. SCOPE 1.1 This practice covers the preparation of 150 mm diameter by 38 to 50 mm (1.5 to 2.0 inches) thick cylindrical test specimens for use in indirect tension dynamic modulus tests. This practice is intended for dense-, gap-, and open-graded hot mix asphalt concrete mixtures with nominal maximum aggregate sizes up to 25 mm. 1.2 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this pro cedure to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to its use. 2. REFERENCED DOCUMENTS 2.1 AASHTO Standards • T 312, Preparation and Determining the Density of Hot-Mix Asphalt (HMA) Specimens by Means of the Superpave Gyratory Compactor. • R 30, Mixture Conditioning of Hot-Mix Asphalt (HMA) • T 166, Bulk Specific Gravity of Compacted Asphalt Mixtures Using Saturated Surface-Dry Specimens. • T 209, Theoretical Maximum Specific Gravity and Density of Bituminous Paving Mixtures. • T 269, Percent Air Voids in Compacted Dense and Open Bituminous Paving Mixtures. • PP XX-XX, Preparation of Cylindrical Performance Test Specimens Using the Superpave Gyratory Compactor 2.2 ASTM Standards • D 3549, Thickness or Height of Compacted Bituminous Paving Mixture Specimens. • ASTM D 5361, Practice for Sampling Compacted Bituminous Mixtures for Laboratory Testing