船用空调通风安装工艺规范.pdfVIP

船用空调通风系统安装施工工艺规范 INSTALLATION AND CONSTRUCTION TECHNICAL RULES FOR MARINE AIR CONDITIONER VENTILATION SYSTEM 一、概述： General 空调及通风系统中需要采用预隔热螺旋风管、 单层螺旋风管、 镀锌薄板矩形风管、 板 材焊接风管 （钢质风管）及通风附件等， 根据设计要求， 落实风管及附件规格型号、 数量， 采用螺旋风管、 镀锌方风管或板材焊接风管， 严格按风管制作工艺和规范要求执行生产安 装。 The air conditioner and ventilation system shall adopt the pre-insulated spiral air duct, single layer spiral air duct, galvanized sheet rectangle air duct, plate welded air duct (steel air duct) and ventilation accessoriesetc. According to the design requirements to determine the type and quantity of air duct and accessories, and select the suitable air duct, i.e. spiral air duct, galvanized sheet square air duct or welded air duct. According to the relative constructure technical rules to manufacture and install. 二、施工程序： 空调工程 A/C PROJECT 风管制作、吊装 AIR DUCT FABRICATE AND LIFT 空调设备安装、空调管道和工艺管道安装 INSTALL A/C UNIT, A/C PIPE AND PROCESS LINE 风管、空调管道和工艺管道清洗 CLEAN AIR DUCT, A/C PIPE AND PROCESS LINE 风管漏光检查 LIGHT LEAK TEST OF DUCT 空调管道和工艺管道试压 PRESSURE TEST OF A/C PIPE AND PROCESS LINE 单机调试 COMMISSIONING OF SINGLE UNIT 风管保温、工艺管道保温 INSULATION OF AIR DUCT AND PROCESS LINE 风管空吹 EMPTY BLOW AIR DUCT 工程验收 PROJECT ACCEPTION 空调系统测试、产品测试 TEST A/C SYSTEM, TEST PRODUCTS 三、风管制作 Manufacture the air duct (1) 镀锌矩形风管 Galvanized rectangle air duct 镀锌矩形风管连接可采用翻边、 铆接和焊接，