净油机控制系统说明书-.docVIP

Gesch?ftsbereich Mechanische Trenntechnik Westfalia Separator Mineraloil Systems GmbH Operating instructions Westfalia Separator Mineraloil Systems GmbH 31 3.1 Fig. 12 The D10 control unit is integrated into the control cabinet door. The operating interface consists of: 1 Softkeys F1-F4 (depending on the current display 2 Display (text display keys 3 System 4 Function keys (when the Edit key has been pressed, numerical values can be entered. 5 Status and fault indicator 6 Operating mode selector (start/stop of CPU 32 Westfalia Separator Mineraloil Systems GmbH 3.1.1 Function keys The function keys have a global function: The actions which can be triggered are independent of the text on the display. They each incorporate an LED which provides information on the state of the respective function. Westfalia Separator Mineraloil Systems GmbH 33 34 Westfalia Separator Mineraloil Systems GmbH 3.1.3 Soft keys F1-F4 3.1.4 Parameter input Numerical input e.g. for passwords or setpoint changes is by means of the function keys. Fig. 13 The corresponding value (1 can be seen on the right above the respective function keys. Note: If by mistake you failed to properly actuate the Edit key when entering parameters, the function of the respective function key is active. You may now possibly change current separator operation. Actuating the wrong key one more time brings you back to the initial separator function condition. If entries are possible in a menu, this mode can be identified by the flashing cursor in the display. Editing values: ? Press Edit key, the LED in the Edit key lights up. ? Enter the new value and/or the password using the function keys. ? Complete your entry by pressing the Enter key. 3.2 Switching on the control unit C7-613 Firmw.:V1.01 Bootl.:V1.01 Startup Fig. 14 When you switch on the control unit, the screen content shown on the left is first displayed. $ 002 transfer Downloading User- Data Fig. 15 Any required data are read in from the Mic