MIL-STD-867D-2019 回火蚀刻检验.pdf

METRIC MIL-STD-867D USAF 24 October 2019 SUPERSEDING MIL-STD-867C 25 November 2008 DEPARTMENT OF DEFENSE STANDARD PRACTICE TEMPER ETCH INSPECTION This standard is approved for use by all Departments and Agencies of the Department of Defense. AMSC: N/A AREA: NDTI Source: -- Downloaded: 2019-11-25T07:07Z Check the source to verify that this is the current version before use. MIL-STD-867D FORWARD 1. This military standard is approved for use by AF70 Hill AF Base, OO-ALC/EN Engineering Program Office, Department of the Air Force, and is available for use by all departments and agencies of the Department of Defense. 2. This standard describes the requirements for the etch inspection of steel components to detect evidence of overheating or flaws in carburization. Etch inspection is typically used for bare low alloy steels heat treated to 180,000 pound per square inch ( 180 ksi/ 1241 Megapascal [MPa])) and higher or carburized parts, however usage is not limited to these applications. This standard may be used where applicable for repair, acquisition, and manufacture of parts and/or spare parts on military components. 3. Beneficial comments, recommendations, additions, deletions, and any pertinent data, which may be of use in improving this document