《J BT 4032-1999电缆设备通用部件牵引装置 系列标准》.pdf

中华人民共和国机械行业标准 电缆设备通用部件 牵引装置 JB/T 4032.1一1999 第1部分:基本技术要求 代替JB 4032.1一1985 Adaptable units of wire and cable machinery Haul-off Part J :General requirements 1 范圈 本标准适用于电线电缆设备的牵引装置。 本标准必须与后续部分一起使用。 2 引用标准 下列标准所包含的条文，通过在本标准中引用而构成为本标准的条文。本标准出版时，所示版本均 为有效。所有标准都会被修订，使用本标准的各方应探讨使用下列标准最新版本的可能性。 GB/T 2900.40-1985电工名词术语 电线电缆专用设备 GB/T 13384-1992机电产品包装通用技术条件 JB/T 7601-1994 电线电缆专用设备 基本技术要求 3 定义 本标准采用GB/T 2900.40规定的定义。 4分类与命名 4.1代号 电缆设备通用部件 ·························································································……T 牵引装置 ······”·····，·························································································一 Q 轮式 ···························，··································。············································……L 履带式 ···················································”············································“·····……D 轮带式 ········································································································……P 主机联动······，·····”······，···················································‘········“···················……W 单独驱动 ······“·····，，························································································一 V 4.2 表示方法 4.2门 牵引装置用型号、规格和标准编号表示。 4.2.2规格具有主参数和辅助参数时，用符号州”分割表示。 4.2.3举例 a)主机联动轮式牵引装置，轮径1 600 mm，双轮。表示为: TQLW-1 600/2 JB/T 4032. 2-1999 b)单独驱动履带式牵引装置，牵引力2 500 N，表示为: 国家机械工业局1999一08一06批准 2000一01一01实施 22 JB/T 4032.1一1999 TQDV-2 500 JB/T 4032. 3-1999 。)轮带式牵引装置，轮径800 mm，表示为: TQP-800 JB/T 4032. 4-1999 5 一般规定 5.1牵引装置的主要尺寸和参数应最大限度地采用优先数和优先数系。 5.2牵引装置的制造质量应符合JB/T 7601规定。 5.3牵引装置的包装应符合GB/T 13384规定。 5.4交货时应附有装箱单、产品检验合格证及使用说明书。 6 传动机构 6.1各种齿轮箱的噪声应不大