MIL-HDBK-103AB-2008 标准规范下载.pdf

NOT MEASUREMENT SENSITIVE MIL-HDBK-103AB 19 MARCH 2008 SUPERSEDING MIL-HDBK-103AA 19 SEPTEMBER 2007 DEPARTMENT OF DEFENSE HANDBOOK LIST OF STANDARD MICROCIRCUIT DRAWINGS This handbook is for guidance only. Do not cite this document as a requirement. AMSC N/A FSC 5962 Source: -- Downloaded: 2008-05-09T04:59Z Check the source to verify that this is the current version before use. MIL-HDBK-103AB FOREWORD 1. This handbook is approved for use by all Departments and Agencies of the Department of Defense. 2. This handbook is for guidance only. This handbook cannot be cited as a requirement. If it is, the contractor does not have to comply. 3. The proliferation of industry prepared drawings for the same part used in a variety of military applications has become an ever increasing item of expense to the DoD. Numerous situations have arisen where one military acquisition document would be more appropriate and cost effective than the multiplicity of contractor prepared drawings. Standard Microcircuit Drawings (SMDs) are being prepared to eliminate the need for the multitude of contractor prepared drawings for the same device when the minimum requirements of SMDs are sufficient to meet the requirements of the application on an interim or permanent basis. 4. Comments, suggestions, or questions on this document should be addressed to: Commander, Defense Supply Center Columbus, ATTN: DSCC-VAS, 3990 East Broad St., Columbus, OH 43218-3990, or emailed to linear@. Since contact information can change, you may want to verify the currency of this address information using the ASSIST online database at . ii Source: -- Downloaded: 2008-05-09T04:59Z Check the source to verify that this is the current version before use. MIL-HDBK-103AB CONTENTS PARAGRAPH PAGE 1. SCOPE1 1.1 Purpose1 1.2 Part or identifying number (PIN)1 1.2.1 Drawing number1 1.2.2 Device class designator1 1.2.3 Case outline / lead finish1 1.2.4 Substitutability1 2. APPLICABLE DOCUMENTS2 3. DEFINITIONS2 4. REQUIREMENTS2