AS2512.7.2-2009 国外国际规范.pdfVIP

1 AS/NZS 2512.7.2:2009 Australian/New Zealand StandardTM A S / N Z Methods of testing protective helmets S 2 5 1 2 Method 7.2: Determination of stability of . 7 . 2 : protective helmets—Dynamic stability 2 0 0 9 PREFACE This Standard was prepared by the Joint Standards Australia/Standards New Zealand Committee CS-097, Testing of Helmets and Visors, to supersede (in part) AS/NZS 2512.7.2:1998, Methods of testing protective helmets , Method 7.2: Determination of stability of protective helmets—Dynamic stability. This test method was devised to determine the likelihood of effective retention in an accident. An important variable in this method is the fit of the helmet on the headform. Because an objective method of measuring fit has not yet been developed, great care is needed to ensure that the helmet chosen for the test is the one which, when seated on the headform and correctly adjusted, most closely resembles an acceptable fit on a person’s head. This test method may also provide a suitable means for testing the dynamic strength of retention systems, depending on the drop height specified in the product Standard. METHOD 1 SCOPE This Standard sets out a method for determining the stability of a protective helmet on a test headform when subjected to a dynamic force. 2 REFERENCED DOCUMENTS The following doc