A635A 635M-04-国外标准规范.PDFVIP

Designation: A 635/A 635M – 041 Standard Specification for Steel, Sheet and Strip, Heavy-Thickness Coils, Hot-Rolled, Carbon, Structural, High-Strength Low-Alloy, and High- Strength Low-Alloy with Improved Formability, General Requirements for1 This standard is issued under the fixed designation A 635/A 635M; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon () indicates an editorial change since the last revision or reapproval. This standard has been approved for use by agencies of the Department of Defense. 1 NOTE—Section 4.1 was editorially corrected in April 2004. 1. Scope* However, unless the order specifies the applicable “M” speci- 1.1 This specification covers the general requirements for fication designation (SI units), the material shall be furnished hot-rolled, heavy-thickness sheet and strip in coils. to inch-pound units. 1.2 It applies to Specification A 1018/A 1018. 2. Referenced Documents 1.3 This material is available only in coils described as 2 follows: 2.1 ASTM Standards: A 370 Test Methods and Definitions for Mechanical Testing Size Limits, Coils Only Product Width, in. [mm] Thickness, in. [mm] of Steel P