温湿度异常处理程序.docVIP

NOPower fan NO Power fan 啟動風車 YES Check temperature at the inlet of chilled water Check 冰水入口溫度 7~10℃ Check the chilled water system and eliminate breakdown Check 冰水系統並排除故障 Check set Temperature 23±5℃ Check 現場溫度 23±5℃ OK Re-set the accurate point 重新設定正確值 Check 3-way open condition Set Point: Open bigger Set Point: Close smaller Check 3-way 開度 Temp 設定值：開大 Temp 設定值：開小 Check DDC Controllers Input and output normal or not Check DDC 控制器 輸入與輸出正常否 NO 3-way motor rotation is difficult or not 3-way 馬達轉動是否困難 Manual control 3-way at the semi-open position 手動控制 3-way 在半開位置 Yes Observe and adjust the 3-way into the proper position 觀察並調整 3-way 在適當位置 Clean 3-way valve 清潔 3-way 閥體 Repair DDC controller 修復 DDC 控制器 Temperature too high 溫度太高 Fan powered or not 風車是否啟動 Yes NO Yes NO Check Set Point of Temperature 23±5℃ Check 溫度設定值 23±5℃ NO Yes Yes Maybe dirty stuff is stuck in the 3-way 可能有髒東西卡在 3-way 內 温 湿 度 异 常 处 理 程 序 温度太高(湿度不控制区域) 温度太低(湿度不控制区域) NO NO Power fan 啟動風車 YES Check Set temperature 23±5℃ Check 現場溫度23±5 Re-set the accurate point 重新設定正確值 Chen condition Set Point: Open bigger Set Point: Close smaller Check 3-way 開度 Temp 設定值：開大 Temp 設定值：開小 Check DDC Controllers Input and output normal or not Check DDC 控制器 輸入與輸出正常否 NO 3-way motor rotation is difficult or not 3-way 馬達轉動是否困難 Manual control 3-way at the semi-open position 手動控制 3-way 在半開位置 Yes Observe and adjust the 3-way into the proper position 觀察並調整 3-way 在適當位置 Clean 3-way valve 清潔 3-way 閥體 Repair DDC controller 修復 DDC 控制器 Temperature too high 溫度太低 Fan powered or not 風車是否啟動 NO Check Set Point of Temperature 23±5℃ Check 溫度設定值 23±5℃ NO Yes Yes Maybe dirty stuff is stuck in the 3-way 可能有髒東西卡在 3-way 內 温度太高，湿度太高 Try to solve Try to solve 設法排除之 Check if there is extra heat source or water vaporization on the spot and the door and window is well closed or not. 熱源 Checkature humidity Check溫濕度設定值23±4℃(5℃)40-65% RH Check if the humidifier moves Check 加濕器是否動作 Check 3-way open condition RH%, TempSet point: Open bigger