76101A接地电阻读数(接地电阻和回路连续性)测试报告.docxVIP

GROUNDING/EARTHING RESISTANCE READINGS (RESISTANCE TO EARTH AND LOOP CONTINUITY) TEST RECORD 接地电阻读数 ( 接地电阻 和回路连续性 )测试报告 ID E76101AR Tag Description 标签号 : Tag No.标签号 : Contract/PO No. 合同/订单号 : Inspection Classification 检查分类 Turnover System 移交系统 : Contractor 承包商 : Contractor QIB WBS Code 工作包编号 : PMT QA/QC Other Location 位置: Test Equipment 测试设备 : (Note 说明 1) 兆欧表 (Note 说明 2) Reference Drawing: 相关图纸 Notes: 注: 1. Record resistance-to-earth for each rod (or group of rods) with all other conductors disconnected. When a foundation is used for grounding/earthing, measure resistance from anchor bolt to earth. Resistance not to exceed: ohms for any single rod, designated group of rods or foundation, when tested in accordance with test method designated in specifications. 记录每个杆棒的接地电阻 (或杆棒组 )连带其他所有断开的导体 .当基础被用来接地的时候 ,测量地脚螺栓到地 面的电阻 .当按照规范指定的测试方法测试的时候 ,指定的单杆和基础 ,对于任何单杆 ,电阻不超过 ___________ 欧姆. 2. Check continuity from each equipment ground/earthing tap to ground/earthing loop bus or rod. If all taps between any two rods (indicate rod numbers below) or all taps connected to bus measure less than ohms, indicate check mark in tap column. 检查从每个设备的接地抽头到接地回路母线或接地杆 . 如果每 2 个接地杆之间的所有抽头 (指出下面的杆编号 )或者 所有抽头连接至母线 的测量小于 ________ 欧姆,指出抽头杆上的核对符号 . Rod Number Or Foundation 接线 杆编号或者基础 Resistance To Earth (Ohms) 接 地电阻 (欧姆) Ambient Temp. ( C- F) 周围环境温度 Weather 天气 Taps ( ) 抽头 Initials/Date 执行人 /日期 NA NA NA NA NA NA NA NA NA NA NA NA NA NA NA Contractor QA/QC Inspector 承包商质量检查员 PMT QA/QC Inspector PMT 质量检查员 If required by approved ITP or Government: 需要 ITP 或政府许可 ( )SE ( ) Vendor ( ) QIB Name:姓名 Name:姓名 Name:姓名 Signature:签名 Signature:签名 Signature:签名 Date:日期 Date:日期 Date:日期