共模干扰原理和测试方法.pdf

Guide on Implementation of Requirements of the Common EPS Draft 7 Aug 28, 2011 Lars Nielsen Foreword: The MoU Signatories have developed this document which identifies certain problems in applying the standards developed by CENELEC and ETSI for the common charger. Particularly as the display technology has been evolving since the original technical specification undertaken by the MOU parties this guide will be the recommendation for the initial common charger placed on the market. The MoU Signatories recommend to other parties planning placing common chargers on the market to meet the requirements and exemptions of this guide. Scope of EN301489-34 V1.1.1: The scope of this standard may give the wrong interpretation that the standard can be applied to any external power supply with a USB Micro-B or Standard-A connector. The correct application of the standard is to external power supplies as defined in EN62684:2010 to allow presumption of conformity to the EMC requirements under the European EMC and RTTE Directives. [References] ETSI ERMEMC(11)031, ERMEMC032. Immunity requirements in EN301489-34: The current requirements of testing immunity at 10Vrms and 10V/m over the whole conducted and radiated frequency bands is significant worse than the original input from the MoU Signatories. Based on discussion and actual experience of immunity issues a proposal will be submitted to ETSI by MoU Companies recommending to: a) Test at 3Vrms conducted and 3V/m radiated across the whole frequency band b) Test at 10V/m at selected frequencies covering the frequency band used for mobile uplink transmission. c) Exclude ripple from the 10V/m testing During monitoring of the output voltage regulation it is recommended to use opto coupler to provide measurement isolation at the output connector/terminals to the measuring equipment. Section 5.4 of EN62684: Clarification of voltage drop caused by the