毕业论文-基于UG的花洒底座的注塑模设计.docxVIP

PAGE II PAGE I 基于UG的花洒底座的注塑模设计 摘 要 通过对制件的材料、结构、性能分析，参考相关资料，考虑塑件的成型方法，初步设计模具方案，初定注塑机。由于制件结构的特殊性，模具采用定模侧抽机构，查阅相关资料，对不同的侧抽机构进行了解、比较，得出最优方案，最终选用斜导柱抽芯机构。接下来对模具的浇注系统、顶出系统、冷却系统等进行论证和设计，由于模具需要顺序开模，还需要对模具结构进行修改，再对模具结构和注塑机进行校核，利用UG NX 8.0/Mold Wizard进行分模和模具各个结构的设计，立体的对模具方案进行设计，并且能够发现各个零部件间的干涉问题，同时还利用Moldflow2014进行辅助设计和分析，对塑件的浇口位置和填充过程进行分析，设计出结构最优，成本较低的模具，并且能够使塑件满足使用性能。 对于第二个制件，首先进行结构分析,需要采用动模侧抽和定模侧抽，模具结构较为复杂。制件内侧为曲面，制件脱模时，因此推杆需要设置止转机构。由于塑件侧抽均为外侧抽，为了使模具结构紧凑建议，动模侧抽使用拨块机构进行侧抽。接下来初选注塑机和标准模架，对模具结构进行设计和布局，并且利用Moldflow进行浇口位置及填充分析。最后利用UG NX 8.0/Mold Wizard进行模具三维设计，完善模具设计。 关键词：注塑模，定模侧抽，UG NX 8.0/Mold Wizard The Injection Mold Design of Shower Base Based on UG Abstract Through the analysis of the material, structure and performance of parts, refering to relevant information, considering the molding method of plastic parts, preliminarily design a moldplan and an injection molding machine. Due to the special structure of parts, molds use fixed mold side pumping mechanism, accessing to relevant information to understand and compare the different side of the pumping mechanism, in order to obtain the optimal solution, finaliy select bevel pillar core pulling mechanism. Next, to demonstrate and design the mold gating system, ejection system, cooling system, mold needs due sequence mold, also needs to modify the structure of the mold, and then check the mold structure and injection molding machine, by using UG NX 8.0 / mold Wizard to part each structure and mold design. Mold three-dimensional design program, and find the interference problem in various parts, and also use Moldflow2014 aided design and analyze plastic parts and gate location filling process in order to design the optimal structure, low cost molds and plastic parts which can meet the performance. For the second plastic parts, firstly analyze structural, requiring the use of the movable mold and the fixed mold side pumping, the mold structure is more complex. The inside is curved parts, and therefore needing to set the rotatio