美国球阀厂家说明-59.pdf

Instruction Manual 377 Trip Valve D200319X012 July 2018 A supply regulator, if used, must have a flow capacity greater than the required combined capacity of the trip valve and actuator. In order to ensure proper selection of a supply regulator, be sure the Cv value of the regulator is greater than the appropriate flow path Cv value listed in table 1 for the trip valve. A regulator with insufficient capacity may allow supply pressure to droop, which can cause the trip valve to trip again and begin a trip‐reset cycle. An example of an appropriate supply regulator to use with a 377 trip valve is a 64 regulator; its capacity is usually great enough to meet the demands of most trip valve/actuator combinations. Determine the requirements of your trip valve/actuator combination for proper selection of a supply regulator. Note During normal operation, an adequately sized supply regulator maintains a greater supply pressure than the pressure demand of the trip valve and control devices. However, if the normal actuator piston position is not relatively close to the actuator piston fail position during startup, or during the restoration of supply pressure, the regulator supply pressure may droop and cause the trip valve to trip again and begin a trip‐reset cycle. To prevent this, perform the following steps: 1. Adjust the instrument (control device) pressure to position the actuator piston as it is positioned in the fail mode. 2. Restore the supply pressure to the normal operating range. 3. Manually reset the instrument pressure for normal operation. WARNING If a flammable or hazardous gas is used as the supply pressure medium, personal injury or property damage could result from fire or explosion of accumulated gas or from con